Revenue Opportunity
Savings Opportunity
Total Revenue and Savings Opportunity
Additional built-in construction elements of our mobile medical trailers, resulting in decades of productive usage
We install a full 4’ x 8’, ¾” thick plywood, laminated on both sides, with fiberglass reinforced plastic, treated with edge sealer, resulting in a water-resistant floor.
An FMVSS 403 & 404, 78” Wide by 42” deep plus a 12” inch ramp, patient lift, is stored in a weather-protected belly compartment quipped with an emergency pump for raising and lowering.
CUSTOM BUILT CABINETRY
Our master cabinet maker builds our cabinets with both European flair and quality. Latches and hinges are all made of the highest quality stainless steel. Our pushbutton stainless-steel latches easily indicate when cabinets are latched (flush when pushed in) to prevent valuable equipment from falling out during transit. All cabinets have solid back panels (not open like most competitors) insuring the strength and rigidity mandatory for long life in a mobile medical trailer.
FRAME/CHASSIS
Our chassis is specially designed so that it will ensure the dependability of expandable side operations and table to gantry alignment. All frames have air-ride suspension, high dampening shock absorbers, and air-ride fifth wheel to protect delicate equipment.
ENERGY SAVING CERAMIC ROOF COATING
Our roofs are coated with ceramic. Developed for aerospace and used on the Space Shuttle for protection from high heat. The ceramic coating reflects 99% of the radiant energy from the sun, provides additional sealant and insulation, and saves energy required for environmental controls. It also provides additional protection from tree limbs and branches.
SPECIAL EPOXY BASED PAINT
We worked with PPG to custom design a paint that is extremely durable and epoxy-based so it will stand the rigors of any climate and condition. The paint is over $500 per gallon, and two coats are applied after the coach has been hand sanded, seams caulked, and a base coat applied. It is so strong that you can literally spray paint the unit and wipe it off with lacquer thinner without damaging the coat.